A-820 Control

Friction Lock Control

Wire End .078 S.S.


This control uses a knurled fitting under the knob to adjust the tension while pulling or pushing the knob or to lock the knob in a certain location.

Rotate the friction lock fitting clockwise to tighten and counterclockwise to loosen.

Knob colors available are: Black (large-2” dia or standard) or White.

Stroke 3-3/8”

Panel nut size ½ x 20 x .8 long

Flexible casing is Teflon lined and .245 Dia. Min bend radius is 6”. Max temp ratings 500-600 degrees.

Most wire end controls like the A-820 will need to be cut to the correct length before installation. To do this first the bag protecting the knob and set aside. Now Pull out the knob, shaft and wire assembly and set aside. With a marker, mark where you want the casing to cut. We have a nice shear to cut casing. For you, a Dremal tool, hacksaw will do. Lightly clamp the casing into a bench vise and carefully cut one coil of the casing on your mark. You can score it slightly and it will break on the score also. Be careful not to kink the casing. Deburr the trimmed casing and reassemble.